16
f) Setting the temperature markers
By default, the spot temperature for the thermal image is displayed on the up-
per left corner of the screen. You can use various settings to mark the actual
measuring point. The middle measuring point can be displayed, in which the
temperature measurement takes place. Similarly, two markers for the lowest
and highest measuring points can be shown in the image.
Centre
The middle spot measuring point is marked as crosshairs. The temperature
is measured here, with the temperature value displayed on the upper left
corner of the screen. The spot measuring point is fixed in the centre and
cannot be changed.
High/Low
The lowest measuring point is marked with a blue frame and the letter “L” in
the image.
The highest measuring point is marked with a red frame and the letter “H” in the image.
These two markers are dynamic and automatically change their position depending on the heat distribution in the
image.
To display the temperature markers, proceed as follows:
• Press the “SET” button to open the settings menu.
• Use the cursor buttons to select the “crosshairs” symbol and press the “SET” button to confirm the selection.
• Use the cursor buttons to select the corresponding parameters. The selected range will be highlighted in colour.
• Press the “SET” button to confirm the selection. The setting is marked with a yellow dot. Both parameters can also
be enabled.
• To exit the menu, press the “Back” button.
