![background image](http://html1.mh-extra.com/html/voltcraft/2527034/2527034_operating-instructions-manual_1047077036.webp)
36
1
Proceed as follows for the line allocation:
-
Switch the receiver unit on by pressing the switch “ON/OFF”
(13). The switch snaps into place and the LED display (1)
shows “00”. The operating indicator “OP” will light up.
- On the remote unit, press the duty switch (16). The operating
indicator “OP” blinks.
- Contact the black banana clips (reference lines) with each
other via a know line.
- Clip the banana clips (19) of the remote unit onto the cable
to be tested. You can contact up to 16 lines per measuring
operation.
- With the red clip (16), contact each of the lines in sequence.
The allocation is indicated on the LED display.
- Once the test is completed, turn the receiver and transmitter
unit off manually (button “ON/OFF”).
The line/cable/pipe allocation can be performed on all conductive and insulated lines, cables and pipes.
The maximum resistance of the line to be tested may not exceed 30 kOhm. If this range is exceeded, the
display shows “00”.
11. Troubleshooting
In purchasing this DMM cable allocator, you have acquired a product which has been designed with state-of-the-art
technology and is operationally reliable.
Nevertheless, problems or faults may occur.
For this reason, the following is a description of how you can eliminate possible malfunctions yourself.
Please always observe the safety instructions!
Error
Possible cause
Remedy
The device does not work.
Is the battery dead?
Check the status. Battery replacement
None change of the
measuring value.
Is a wrong measuring function
activated (AC/DC)?
Check the display (AC/DC) and switch the function
if applicable.
Is the HOLD function activa-
ted? (display “HOLD”)
Press the key “HOLD” to deactivate this function.
Repairs other than those described should only be carried out by an authorised specialist.