g) Relative value
This stores an existing reading (a delta) and resets the display to zero. It is a relative reference
point to measure against the next reading.
• This mode is only applicable with the following functions: LOZV , V , V , mV , µA
, mA , A , LPFV , Resistance, Capacitance, Temp.
• Short press the REL/MAX MIN button to enter or exit REL measurement function.
• The symbol will show.
13. Replacing the Fuse
Never operate the meter if the case is open. !DANGER TO LIFE!
1. Turn the function dial to the “OFF” position.
2. Remove the test leads from the input
terminals.
3. Unscrew then remove the battery cover.
4. Unscrew the rear cover screws.
5. Replace the fuse with one that is of the same
type and specification. Refer to the section
“Technical data” for further information.
6. Carefully replace the covers.
14. Troubleshooting
Problem
Possbile cause
Suggested solution
The DMM will not
power up.
Flat battery
Replace with new battery.
62