Vollrath SLR7009/N, Руководство оператора

Страница: 4 / 8

C
ountertop
C
ooking
e
quipment
O
peratOr
’
s
M
anual
4
B
lade
r
emoval
, m
odelS
40801
and
40797
only
,
Safe Blade
removal tool
1. Loosen the securing knob (A) and remove the blade cover (B). See
Figure 3.
a
B
c
Figure 4. safe Blade Removal Tool and Blade and sharpening Assembly
2. Clean the front side of the blade (B) prior to using the safe blade removal
tool (A). See Figure 4. Clean the equipment with a damp cloth and mild
soap
3. Lift the knob (C) and sharpening assembly to the “UP” position.
4. Set the safe blade removal tool (A) onto the blade (B) aligning with center
blade hole.
5. Screw the two knobs (D) into the corresponding holes on the blade (B) and
tighten the knobs (D). See Figure 5.
d
d
a
c
B
e
Figure 5. safe Blade Removal Tool and Blade
6. Unscrew the safe blade removal tool (C) while holding the crossbar (E).
7. Lift the safe blade removal tool (A) and blade (B). See Figure 6.
a
B
c
Figure 6. Tray Knob, stud and Product Tray
8. Clean the back side of the blade (B) and other exposed parts of the
equipment. Clean the equipment with a damp cloth and mild soap. Do
not use abrasive detergent or cleaning materials as they can damage
the inish of the slicer. Remember that the blade is extremely sharp.
9. Wipe the equipment dry with a clean cloth and allow to dry before using
again.
10. Set the safe blade removal tool (A) and blade (B) into the center hub
(C). See Figure 6.
11. Rotate the safe blade removal tool (A) and blade until it its onto the hub
pins.
12. Slowly turn the handle (C) to thread the blade (B) on while holding
the cross bar (E). See Figure 4. Use caution not to cross-thread the
blade (B).
13. Tighten the blade (B).
14. Unscrew the two knobs (D) while holding the cross bar (E). See
Figure 5.
15. Remove the safe blade removal tool (A) and lower the sharpening
head (C). See Figure 4.
16. Install the blade cover (B) and tighten the securing knob (A). See
Figure 3.
r
eSet
S
witch
The reset switch is actuated to protect the motor when the slicer is submitted
to a mechanical type of overload. In case of overload:
1. Turn the on/off switch (F) to the “OFF” position. See Figure 1.
2. Remove the item(s) that caused overload. If necessary clean the
equipment following the
Cleaning Section
of this manual.
3. Press the reset push-button, located on the bottom of the slicer.
4. Turn the on/off switch (F) to the “ON” and resume operation.
Activation of the reset switch occurs rarely, but if it is activated often during
normal use, please contact a Vollrath authorized repair service center.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901