055 0005
Receiver Installation
(without trim ring)
3
1.
Secure
receiver mounting bracket
to dash with screws previously removed
from dash opening.
2.
Connect receiver wiring adaptor to receiver following instructions supplied with
wiring
adaptor.
3.
Remove
DIN sleeve
and
trim ring
from receiver if in place (Figure 1).
Note:
The trim ring will not be used in this installation.
4.
Slide DIN sleeve into receiver mounting bracket and secure to
bracket by bending the
securing tabs
(Figure 2).
5.
Hold receiver near dash. Connect receiver wiring
adaptor to factory harness. Plug antenna lead
into rear of receiver.
If using an antenna adaptor:
Be sure the antenna cable
(lead) is plugged in and the blue power wire of the antenna
adaptor is properly connected.
6.
Slide receiver fully into sleeve and
test operation.
7.
Install
receiver faceplate “A”
(supplied with installation kit)
by snapping into place.
Receiver Mounting Bracket
Receiver Faceplate “A”
FIGURE 2
FIGURE 1
DIN Sleeve
Trim Ring
Securing Tabs
Bend tabs after sleeve
is inside receiver
mounting bracket.
1-800-955-9094
TECHNICAL SUPPORT
Please read first
•
Inspect factory receiver harness connector in vehicle.
Ensure that the wiring adaptor received from Crutchfield
plugs into the vehicle’s connector. If the connector is
missing or incorrect, please call our
Technical
Support Department
at
1-800-955-9094
.
NOTES: