055 0005
Door Speakers
5
1.
Pry
off
door pull handle cover
. Remove two
(2) exposed phillips screws from door pull handle.
2.
1998- 2002 models:
Remove two (2) Torx
T20 screws from bottom of door panel.
2003- models:
Remove three (3)
Torx T20 screws
from bottom of door panel.
3.
Pry out bottom and sides of door panel to
release six (6) retaining clips. Lift door panel
firmly to release. Disconnect wiring harnesses
and
door release cable
to remove door panel
(Figure
1).
4.
Use a drill and 3/8” bit to drill out
rivets
securing
speaker assembly
to door. Pull out
assembly, disconnect and remove (Figure 2).
Use a nail punch to knock out remains of rivets in
mounting
surface.
5.
Secure new speaker to speaker adaptor
bracket. Place speaker/bracket assembly in
location and mark new mounting holes. Remove
speaker and drill new holes with a 1/8” bit.
6.
Connect speaker wiring adaptor of
replacement speaker to vehicle speaker
harness. Secure speaker/bracket assembly
to location (Figure 3).
7.
Test speaker operation and reinstall door panel
by reversing removal steps.
FIGURE 2
Rivets
Speaker Assembly
Door Pull
Handle Cover
FIGURE 3
FIGURE 1
Door Release
Cable
Note:
Door panel for 2003- models
is slightly different in appearance, but
removal steps are the same as 1998-
model shown.
1-800-955-9094
TECHNICAL SUPPORT
Always be careful when drilling in a vehicle. WEAR EYE
PROTECTION. Be aware of things such as wiring, windows,
fuel lines and safety devices. Check drilling depth and
location to avoid damage to vehicle appearance.
CAUTION:
!
NOTES:
Please read first
•
Instructions show factory size speakers or speakers
with adaptor brackets only. Cutting or fabrication (not
shown) will be required for other speaker sizes.
If vehicle is equipped with Monsoon system, a speaker mounting
bracket must be fabricated in order to install an aftermarket
speaker. An adaptor is available for non-Monsoon applications.
IMPORTANT:
!
Check that wires do not interfere with window operation.
Test door lock and release operation.
SAFETY CHECK
!
