A. Safety Instructions
AdminGuide-Voss12-1.docx
117
Never bend or tune the plug. If the packed plug is damaged, contact
manufacturer and exchange it.
Power adaptor should have three point of contact. This plug only can be
applied on grounded power outlet. This instruction is particularly for operator
safety and correct system function. Proper grounding of the electrical outlet
can be verified by a certified electrician. Also, for safe operation, the system
power consumption should not exceed 80% of total the connected power
supply. For this problem, contact a certified electrician.
Check whether the power lines are lines up properly, and near to the system.
Connect the power adaptor to the nearest power outlet to avoid pulling out the
plug due to high tension.
Do not put too much force when plug-in and plug-out.
■
Overheating and Cooling
Once the system power is on, the system temperature increases. Moreover,
VOSS12 is small device, so its temperature can be warmed up. Regarding the
overheating, please follow the instructions below.
While operating the system, the device temperature goes up. So do not touch
the system during operation. It may disturb radiating the heat.
Do not place any flammable material near the device.
For safe operating, VOSS12 composed with vents, radiant heat panel. So, if
the device is near from any heating machine or too near to wall or covering
the system may cause overheating the system and this will damage the system.
In order to optimize the system capacity, please follow the instructions below.
Before connect the power, the system should be fully assembled.
Dust on the system should be removed regularly.
The Vents and any hole in the device should be cleaned.
Do not cover both side of the system.
The system temperature should no be over 40
℃
■
Additional Safety Instruction
CAUTION
: Be careful while handling power, telephone and cable. In order to
avoid electronic shock, always turn off the system and disconnect all the cables
before maintain the system. When reconnecting the power, connect the all the
phones and cables first. And then power on the system at last. Use the power
adaptor which provided with the device only and connect the socket which has
FE(Frame Earth).
CAUTION
: In order to avoid fire or electronic shock, do not turn on the system
near water.
Keep away from fire.
Keep away from water.
Do not repair or discompose.
CAUTION
: While inserting a board, follow the instructions below.
In order to avoid electronic shock, always power off the system when disassemble
the system before inserting boards. Be careful while handling power cable or phone
cable, or LAN cable.
CAUTION
: In order to avoid fire or electric shock while setting up, follow the
instructions below.
Never install telephone line when lightening or storm.
Never Install telephone line jacks in wet locations unless the jack is specifically
designed for wet location.
Be careful while installing telephone line or maintaining the line.
Use No. 26 AWG or thicker line as safety instruction.
CAUTION
: Keep away the plastic pack from children hands.
Never install telephone line when lightening or storm.
