Vogt P-24AL, Руководство по обслуживанию

Страница: 117 / 149

P24AL & P34AL Service Manual
OPTIONS AND ACCESSORIES
12/2016
10-7
Parameter Minimum Maximum Default Recommended
Settings
Unit
Line Side Voltage (Nominal
Voltage)
90 650 208
Supply voltage
Volts
Under /Over Voltage (tolerance) 6 18 12
10
%
Phase Unbalance 2 25 6 5 %
Lockout Time (Delay on Break) 0 720 30 120 Seconds
Delay Time (Delay on Make) 0 30 0
0
Seconds
Response Time (Delay on Fault) 0.1 20 2 2 Seconds
Control Off / Auto / On Auto On N/A
Contactor Test OFF 5 OFF OFF Volt Diff
Table 10-2
Power Monitor Parameter Limits
Parameter Adjustments
Active display of Line Voltage (this is the default normal display).
Active display of
Load Side Voltage (if connected).
Voltage Set Point (VAC Flashes) . The value may be adjusted by pressing the up and down arrows.
This may be set to the normal operating voltage of the device being protected in one volt increments.
Under/over Voltage Tolerance in % (UNDERVOLTAGE/OVERVOLTAGE flashes). The
value may be adjusted by pressing the up and down arrows.
Imbalance Voltage Tolerance in % (% IMBALANCE flashes). The value may be adjusted by
pressing the up and down arrows.
Lockout Time in seconds (SECONDS flashes) . The value may be adjusted by pressing the up and
down arrows. (This is the delay on break timer value)
Delay time in seconds and tenths of seconds (RESP. SECONDS flashes). The value may be
adjusted by pressing the up and down arrows. This is the time that a fault is allowed before
shutdown occurs.
Control mode (ON OFF AUTO flashes). The value may be adjusted to OFF (load will not turn
on), ON (load will turn on whenever there are not faults and timers are finished) and AUTO (Load
will turn on when there is a control input).
Contactor fault monitor mode (CONTACTOR FAULT flashes). This option allows you to
monitor the contactor and lock it out if the line voltage and load side varies by more than 5 volts.
Pressing the up and down arrows selects off (default) or on. The load side of the contactor must be
connected to the load terminals of the DTP-3 to use this option.