www.vogels.com
M6 x 16mm
M6 x 25mm
M8 x 16mm
M8 x 25mm
5/16” Washer
5/16” x 3”
Lag Bolt
Universal
Spacer
Universal
Washer
Finned Anchor
2.5mm Allen Key
Depth Measuring
Straw
Level
4mm Allen Key
Phillips
Screwdriver
Protective Eyewear
Hammer
Leveler
Electronic Stud
Finder
Pencil
Drill Gun
2.5mm Allen Key
10mm Socket
Template
x4
x4
x4
x4
x4
x4
x8
x4
x4
1/4” / 6mm
Drill Bit
3/8” Concrete
Drill Bit
Socket Wrench 13mm or 1/2”
Socket
x1
x1
x1
x1
x1
4
A2
A1
Remove the plastic hole covers from the upper and lower
plates. Loosen the (2) set screws on the plate using the
2.5mm allen key supplied. Reposition the upper and lower
pivot rods to mate to either the center or right side pivot
receiver holes, push the upper and lower plate fully on to the
rods, and re-tighten the set screws. Reinstall the side plate
with the eight flat head screws and confirm they are secure.
Reinstall the round plastic hole covers.
Prior to initial step 1 of the installation, your PFW 6850 can
easily have the main “swing left” pivot point of the main swing
out arm moved to either the center, left or right of the mount
by simply placing the mount on a flat surface and removing
the eight flat head screws, then separating the upper and
lower wall plates.
Included components
Required for installation
Pivot
Set Screw
Locations
Set Screw
Locations
