www.vogels.com
1
2
15
14
13
12
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
PFW 6850
We recommend where possible that the power and signal
cables be run separately through the mount until mating at
the display plug in points to minimize possible “cross talk”
interference. With the covers removed, cable can be run
inside the upper and lower main arm and through the slots
behind the plastic beauty covers.
Install the upper and lower “push on” plastic “beauty covers”
to the upper and lower wall plates. Reinstall the upper and
lower plastic cable covers to the mounts main swing arm.
Installation complete
10mm Deep Socket
2.5mm Allen key
2.5mm Allen key
Tilting of the display on the mount is easily accomplished by
placing one hand on top of the display edge center and one
hand on the bottom of the display edge center and gently
pulling out on the top edge to the desired tilt angle. No lock-
ing of the set tilt angle is required as the mount has built-in
friction control. If additional tension is required, use the
socket and M4 allen key to adjust the desired tension.
Extra tension can be applied to the pivot of the arms by
tightening the nuts on the arm with supplied 10mm deep
socket, and the set screws on the base with the supplied
2.5mm allen key. NOTE: Do not over tighten.
