VocoPro STAGE-MAN, Руководство пользователя

Страница: 24 / 28

24
There is no power
. Make sure the power cord is firmly connected to the back of the unit and
to the power outlet.
. If using a power strip/surge-protector, make sure that it is plugged in
and switched on.
There is no sound
. Make sure the MASTER and CH 1-3 LEVEL VOLUME knobs are set to an audible
level.
. Make sure headphones are not connected. Connecting headphones disables the
main speaker output .
. If using microphones, make sure they are connected properly and cables are
not defective.
. If using an external player, make sure they are connected properly and
cables are not defective.
. If an external effects device is connected, make sure it is powered on.
The sound has static
. Check the EQ settings. You may have set the EQ settings too high.
. You may have a line-level signal connected to the CH 1-3 inputs. Connect
only mics or music instruments to the CH 1-3 combo jacks.
(Optional Wireless Channels)
No sound output, RF/AF LED(s) are not glowing
. Make sure the microphone power switches are set to the ON position.
. Make sure the UHF POWER on the main unit is set to ON.
. Check microphone batteries to ensure that they are providing sufficient
power. Replace battery if necessary.
. Make sure antennas are firmly connected and extended to an optimal
position .
. If necessary, reduce the distance between the microphones and receiver.
. Talk into the microphone and observe the module’s RF/AF signal LEDs. If
they glow, the problem is else where in the sound system.
Received signal is noisy or contains extraneous sounds with the
microphone(s) ON.
. Make sure everything is connected firmly and properly
. Make sure there are no defective cables
There is noise coming from the receiver with the microphones turned OFF.
. This is called interference. Remove local sources of UHF interference,
such as lighting equipment. In some locations this may be unavoidable due to
a frequency conflict. Contact VocoPro tech support for more information.
Momentary loss of sound as microphone(s) are moved throughout the operating
range.
. Reposition the receiver, perform a “walkthrough”, and observe the signal
strengths. If audio dropouts persist, mark these “dead spots” in the
operating area and avoid them during the performance.
(SDR-3 Recorder)
SDR-3 is not recording to SD card
. Make sure the SD card capacity is 1GB or less
. Make sure there is sufficient room to record (1MB per minute, on average)
Troubleshooting