B3000 Quick Reference Guide
– 18 November 2021
4
To send a numeric page: Press the Call button, wait for the Genie to answer, and then say:
•
Page
<person’s first and last names>.
•
Dial a pager number.
* Requires permission from the system administrator.
Hold and Do Not Disturb
To hold a call in progress:
Press the Hold/DND button on the top of the badge.
To release the hold:
Press the Hold/DND button again.
For Do Not Disturb mode:
Press the Hold/DND button when no call is in progress. Press it
again to release Do Not Disturb.
Call Waiting
If you hear the Call Waiting tone while you are on a call, it means another party is trying to call
you. You can look at the badge display to see who is calling.
•
To take the call:
Press the Call button. The first call is put on hold and the second call is
connected. To end the second call and return to the original call, press the Call button
again.
•
To refuse the call:
Press the Hold/DND button.
Charging the Battery
The following steps show a
single-bay charger
, but you may also use an
eight-bay charger
.
There are two indicator lights on the charger,
blue
for capacity, which decreases over time, and
green/red
for charge status
1.
Use your thumb to press the battery latch and lift it up, and
then remove the battery.
2.
Insert the battery into the charger, label facing back, and
press down on the battery until you see the blue light turn on.
After a second, the green light will begin to blink.
Note:
If the blue light remains on and is steady, the battery is
beyond its useful life. If so, replace it.
3.
When the green light stops blinking and is steady, the battery
is fully charged. Remove it from the charger.
4.
Slide the pegs at the top of the battery into the two holes in
the badge's battery compartment and press down gently to
seat the battery in the badge.
