VMAC
– Vehicle Mounted Air Compressors
Toll Free:
1-888-241-2289
Fax: 1-250-740-3201
48
Replacing the Compressor Air Filter
Read the
“Maintenance and Repair” safety section
before working on the system.
Never run the compressor, drive the vehicle or
even allow the vehicle to sit parked without the
recommended air filter and filter cover installed.
1) Clean loose debris from the area around the compressor and the
filter cover to prevent contamination entering the compressor.
2) Remove the filter cover retaining screw (rotate counter-clockwise),
the filter cover and the filter element.
3) Immediately cover the compressor opening by masking with tape or
with a clean cloth to prevent contamination. Do not use compressed
air or perform any other tasks around the compressor until the filter
and cover are replaced.
4) Clean the inside of the filter cover with a clean, dry cloth. Do not use
flammable solvents to clean the inside of the cover.
5) Remove the cloth or masking and install a new air filter. Ensure that
the filter fits over the step on the filter plate.
6) Replace the cover and secure it with the cover bolt (rotate
clockwise). Do not over-tighten the bolt.
Figure 35 - Compressor air filter and cover
Содержание RAPTAIR-G30
