VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
29
Installing the Air Intake
Figure 32 — Installing the remote air intake housing
☐
Install the short side of the supplied rubber elbow onto the inlet and secure it
using a gear clamp (Figure 32).
☐
Install the steel connector tube into the top of the elbow.
☐
Adjust the rubber elbow and tube assembly to ensure they are routed away
from any hot, sharp, or moving components. If required, trim any extra length
from the hose to allow for the best routing.
☐
Route the supplied flexible hose from the remote regulator, down toward the
driver side frame rail.
☐
From the wheel well, pull the hose down, and route it toward the PTO.
☐
Using the supplied gear clamps, attach the flexible hose to the connector tube
Figure 33 — Installing the air filter
Flexible hose
Front drive shaft
(4WD only)
Front of vehicle
