VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: www.kb.vmacair.com
26
☐
Route the 1/2 in hose (cooler to compressor) between the frame and the AOST,
and down through the forward AOST bracket (Figure 27).
☐
Route the 3/4 in hose over to the control arm, past the control arm mount and
around to the transmission crossmember (Figure 27).
☐
Apply the supplied spiral loom to the 3/4 in hose where it runs along the control
arm mount and wraps around to the rear of the control arm to provide abrasion
protection.
☐
Using a cable tie, secure the 3/4 in hose to the control arm mount.
☐
Route the 3/4 in hose, and 1/2 in hose over to the transmission crossmember, and
along the front of the crossmember to the driver side of the vehicle (Figure 28).
Figure 27 — Routing the hoses
1/2 in hose
(Cooler to compressor)
Apply loom
Figure 28 — Routing the hoses
Apply heat
wrap
