www.vizi-tec.com
November 26, 2017
Page 18 of 24
Contact
What is “T” and when is the 7 time segments? What is its maximum?
Each profile is segmented into 7 parts. Hence (T0 - T6). Only one segment can be active at a given time. After a successful
modulation burst the profile resets to (T0) during its GRACE_PERIOD and SLOPE attribute. Then moves on to T1.. T2.. and so
forth up to T6 and stays there(T6) until next braking cycle.
Example:
Grace Period = ‘12 seconds’
Slope = ‘Slope5’
Modulation = ‘Standard’
Page 17 shows that with SLOPE_5 with a 12s Grace Period. The max values are T0=12s, T1=24s, T2=36s.. T6=84s. That
means during T0(between 0s to 12s) there will be no modulation. Hence “grace period”. T0 expires at >12s. Next segment
T1(>12s to 24s) there will be 2 pulses if brake is pressed based on the ‘Standard’ modulation attribute. T1 expires at 24s.
Next segment between T2(>24s to 36s pules goes up to 3. Last segment T6 and above there will 8 pules.
How can I get more modulation?
Change attribute#3. See page16 for a chart.
Example:
From above question. Profile had attribute#3 = ‘Standard’. If it was set to ‘Aggressive B’. Then at T1 it would have generated
4 pulses instead of the 2 from a ‘Standard’ setting.
How is this different than other modulators out there?
The low down is that the output is NOT based on a fixed set of pulses as seen on other modulators on the market. But rather
how much, how fast, how soon and when you program it to burst.
Lost or have questions?
Send us an email at [email protected]
