ViVOpay 8850 User Guide
2
Getting Started
Unpacking the ViVOpay 8850
The ViVOpay 8850 requires a data cable and a power supply if the data cable is not supplying power.
Data cable and power supply are not included with the ViVOpay 8850 and should be purchased
separately from ViVOtech. Verify that you have all the required components for the installation.
You may also need the following:
•
Additional SAM card
•
Four M3 screws
If you want to secure the reader to a surface you need four M3 screws of the appropriate length
(not supplied).
•
Contactless test card (ViVOcard Contactless Test Card P/N 241-0015-03)
•
Magnetic stripe test card
•
Wedge bracket kit (540-0006-00)
The ViVOtech data cables and power supply are specifically designed to meet FCC requirements. If
you are using other cables or power supply, you must install ferrites available from ViVOtech. For
your free ferrite core kit with installation instructions, please contact ViVOtech support.
ViVOpay 8850 (P/N 540-XXXX-XX)
Stylus and cable (P/N 200-2515-00)
Note:
The stylus may not be required if the POS
application used with the ViVOpay 8850 is not using
signature capture.
Data cable (varies by POS and length)
• Serial Data Cable (P/N 220-2463-0X)
• USB Data Cable (P/N 220-2462-0X)
These cables are recommended and approved by
ViVOtech to comply with FCC rules and regulations.
Power supply, if required
• US/North America (P/N 140-2035-04)
This power supply recommended and approved by
ViVOtech to comply with FCC rules and regulations.
