Vivitek DK10000Z, Руководство пользователя

Страница: 42 / 62

DK10000Z Series DLP Projector - User Manual
UM100000823EN03
42
HDR
Compared with High HDR (Dynamic Range Imaging) and SDR (Standard Dynamic Range), HDR can make the bright
area more bighter, Dark area more darker. The color performance will better then traditional SDR, especially the
high-brightness block in the picture will has better reduction.
Must enter the Gamma option and activate the HDR function, then you can adjust HDR details options, the details
adjustable options are Off / Auto / PQ-400 / PQ-500 / PQ-1000 / HLG.
Input Balance
When ambient light is too bright or changes, the projected image details may be affected, you can adjust the option
to make the projected colors of image closer to desired colors. There are two options for fine tuning Red, Green and
Blue
Offset These three options will shift the color spectrum for the whole image and change its brightness, if mini-
mal amount of red, green or blue appears in the gray areas, you can adjust the offset of the correspond-
ing color accordingly. By increasing the offset, the image brightness will become lower.
Gain
These three options are used to increase or decrease the range of color input for the entire image. If
minimal amount of red, green or blue appears in the gray areas, lower the gain of the corresponding
color accordingly. As gain increases, the contrast of the image will become lower.
HSG
HSG is a function to adjust Hue, Saturation and Gain independently, it allows for specified color adjustments that
are more intuitive. You can adjust Hue, Saturation and Gain for Red, Green, Blue, Cyan, Magenta, Yellow and white
independently.
Noise Reduction
Use ◄► to adjust the noise of the projected image. This function is used to remove the noise of the image with inter -
laced scanning input. Generally, noise reduction can lower the high-frequency details and make the image softer.
Dynamic Black
This is function can be used to enhance the black level of the projected image.
Light Off Timer
User can decide how many seconds after projector detets dark image then projector automaticaly turns off the laser
light to get the better contrast.
Smooth Picture
If input signal is 4K, suggest to set this function “On” or "Auto" to get better projection image.