10
The second way to adjust the crease pressure is a mechanical setting. Remove
the head cover as shown in figure 3.17 by loosening the 3 silver knurled knobs
on either side of the head.
Once removed, you will require a 22mm and 17mm spanner [these have been
provided with the machine]. Place the 22mm spanner on the Crease solenoid
[figure 3.18] and the 17mm spanner on the locking nut [figure 3.19].
Once the locking nut is loose, turn the solenoid shaft anticlockwise to lower
the crease wheel or clockwise to higher. When you are at your desired height
tighten the locking nut and return the head cover.
Figure 3.17
Figure 3.18
Figure 3.19
Содержание Veloblade Volta
Страница 1: ...0 Introduction User Manual for...
