Operating manual Omni-Flow
Edition 1.0. 09/2017
15 / 32
Test sheet
7.4
1. In order to activate the test sheet, Matrix Laminating System is switched on, the paper is aligned (
chapter
7
), the channels are set (
chapter 7.1
) and the job details are entered. For more detailed information on
entering a job see from
chapter 8
.
2. Press and hold the
table up button
until the
stacking table
stops automatically in the top position.
3. Press once by a short tip the
Start button
. The feeder is now automatically adjusting the pile height.
The fans for separating the air start to run. The
LED
flashes quickly.
4. After a few seconds, the
LED
flashes slowly.
5. To send a test sheet to the feeder, press either shortly the
START button
or press direct on the
Touchscreen
the
T
button.
7.5 Switching on automatic mode
The automatic mode is designed to raise the
stacking table
automatically after each sheet so that the top
sheet is always at the same height.
1. In order to activate the test sheet, it is required that the Matrix is switched on, the paper is loaded (
chapter
7
), the channels are set (
chapter 7.1
) and the job details are entered. For more detailed information on
entering a job see from
chapter 8
.
2. Press and hold the
table up
button
until the
stacking table
stops automatically in the top position.
3. Press once by a short tip the
Start button
. The feeder is now automatically adjusting the pile height.
The fans for separating the air start to run. The
LED
flashes quickly.
4. After a few seconds, the
LED
flashes slowly.
5. Hold the
START button
for 2 seconds
. The machine changes to the auto mode, the
LED
is illumi-
nated continuous. The paper feeding process starts.
Please note:
For safety reasons, the automatic mode can only be activated manually.
It is automatically deactivated as soon as the machine is switched off, a paper jam occurs or a
cover / slide is opened while the machine is running.
