Operating manual Omni-Flow
Edition 1.0. 09/2017
11 / 32
6
Installation
Installation instructions
6.1
During the whole installation process (chapter 6), the machine or any
of its parts must not be connected to power.
6.1.1 Installation location
The unit must be installed on a flat surface. If necessary it can be adjusted horizontally with the height ad-
justable feet.
Depending on the processing speed and the paper used the unit might make noise. Install it in a place
where it does not disturb the environment.
Operate and store this unit only in an environment
with a temperature range between 5 and 35° C (storage conditions: -10 and +50° C)
with a humidity range between 10 and 85% RH (no dew condensation)
which is subject to no or very little vibration
without any harmful chemicals
which is reasonably dust-free
where the equipment is not exposed to water
6.1.2 Power supply
Make sure the power supply is always within the following range: 100
–
240 V, 50/60 Hz
If you power several devices through one power outlet make sure that their combined power consumption
does not exceed 10A.
The equipment has an Appliance Inlet Coupler C20 acc. to IEC 60320-1.
The power supply cord must be of a type acceptable to the authorities in the country where the equipment
is sold.
For the USA and Canada:
It must not be longer than 4,5 m in length, compatible with Tables 11 and 12 of the CEC and Article 400
of the NEC and not less than AWG14
For Europe: Conductor cross-section must not be less than 1,5 mm².
6.1.3 Maintenance
To protect the special features of this unit, the customer should never apply oil or grease to the parts. Please
contact your service technician in case of any problem.
