Vitek VT-8242, Инструкция по эксплуатации

Страница: 7 / 44

7
ENGLISH
Let the unit cool down for 10-15 minutes and switch it on again.
Do not block the air inlets during the hot air styler operation and
avoid getting of hair into the air inlets.
CLEANING AND CARE
•
Set the switch (4) to the position «0» and unplug the unit,
wait until the thermo brush cools down completely.
•
Remove the thermo brush (1 or 7) from the hot air styler
body (5).
•
Clean the thermo brush off hair.
•
Wipe the unit body (5) with a damp cloth and then wipe it dry.
•
Clean the air inlet grid with a brush.
•
Do not immerse the hot air styler body (5), the power cord
and the power plug into water or other liquids.
•
Do not use abrasives and solvents to clean the unit body.
STORAGE
•
Disconnect the unit from the mains and clean it.
•
Never wind the power cord around the hot air styler body (5),
as it can damage the cord or the unit body.
•
Handle the power cord with care, do not pull, twist or stretch
it, especially near the power plug or at the junction point.
Periodically straighten the cord if it gets twisted during the
hot air styler operation.
•
For easy use of the hot air styler, it has a hanging loop (6) you
can hang the unit on, provided that no water gets on the unit.
•
Keep the unit in a dry cool place out of reach of children and
disabled persons.
DELIVERY SET
Hot air styler – 1 pc.
Thermo brush 40 mm in diameter – 1 pc.
Thermo brush 50 mm in diameter – 1 pc.
Instruction manual – 1 pc.
TECHNICAL SPECIFICATIONS
Power supply: 220-240 V ~ 50 Hz
Rated input power: 1000 W
ATTENTION! Do not use the unit near water in the bathrooms,
showers, swimming pools etc.
IM VT-8242_70x130.indd 7 04.09.2018 17:26:04