Vitek VT-8242, Инструкция по эксплуатации

Страница: 5 / 44

5
ENGLISH
•
Check the power cord and power plug insulation integrity
periodically.
•
Do not attempt to repair the unit. Do not disassemble the
unit by yourself, if any malfunction is detected or after it was
dropped, unplug the unit and apply to any authorized service
center from the contact address list given in the warranty
certificate and on the website www.vitek.ru.
•
To avoid damages, transport the unit in the original pack-
age only.
•
Keep the unit in a dry cool place out of reach of children and
disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, ITS
COMMERCIAL USAGE AND USAGE IN PRODUCTION AREAS
AND WORK SPACES IS PROHIBITED.
USING THE HOT AIR STYLER
After unit transportation or storage at low temperature
keep it for at least three hours at room temperature before
switching on.
•
Unpack the hot air styler and remove any packaging materi-
als that can prevent the unit operation.
•
Unwind the power cord completely.
•
Install one of the thermo brushes (1 or 7). To do this insert
the thermo brush (1 or 7) into the hot air styler body (5)
downwards until bumping.
•
Before switching the unit on, make sure that your
home mains voltage corresponds to the unit operating
voltage.
•
Make sure that the operation mode switch (4) is set to the
position «0».
•
Insert the power plug into the mains socket.
•
Set the required settings of the air flow using the switch (4):
«
0 » – the hot air styler is switched off;
« 1 » – low speed and low temperature;
« 2 » – high speed and high temperature;
« » – «cool» air supply.
•
You can change the thermo brush (1 or 7) rotation direction
with the buttons (3). During the operation press and hold
down the button (3), the thermo brush (1 or 7) will rotate in
the required direction.
Note: during the first operation some foreign smell from the
heating element is possible, this is normal.
IM VT-8242_70x130.indd 5 04.09.2018 17:26:04