Vitek VT-8242, Инструкция по эксплуатации

Страница: 6 / 44

6
ENGLISH
•
After the hot air styler operation is finished, switch
it off by setting the switch (4) to the «0» position and
unplug it.
•
Wait till the thermo brush cools down.
•
Remove the thermo brush (1 or 7), to do this press simul-
taneously on the clamps (2) and remove the thermo brush
(1 or 7) upwards.
USING THE THERMO BRUSH
To get the best results, wash your hair with shampoo (before dry-
ing and styling), dry it with a towel to remove excessive moisture
and comb your hair.
•
Install the thermo brush (1 or 7).
•
Insert the power plug into the socket, switch the hot air styler
on and set the required heating mode and air flow intensity
with the switch (4).
•
Divide the hair into locks.
•
Wind a lock of hair on the thermo brush (1 or 7) select-
ing the brush (1 or 7) rotation direction with the buttons
(3); when the hair lock is wound around the brush, release
the button (3), and the thermo brush (1 or 7) rotation
will stop.
•
Dry your hair for some time (depending on your hair type),
controlling the temperature and intensity of the air flow with
the switch (4).
•
To fix the lock set the operation mode switch (4) to the posi-
tion «
», the air flow temperature will decrease that helps
to fix the hair style.
•
Remove the thermo brush (1 or 7) from the hair lock.
Note:
– if it is hard to remove the brush attachment from the hair,
switch the hot air styler off by setting the switch (4) to
the position «0», disconnect the thermo brush (1 or 7)
from the unit body (5) and carefully remove it from the
hair lock;
– avoid contact of heated surfaces of the thermo brush
(1 or 7) with your face, neck and other parts of your body.
OVERHEATING PROTECTION
Overheating protection switches the hot air styler off if the
outgoing air is too hot. If the hot air styler is switched off during
operation, set the switch (4) to the position «0», unplug the unit
and make sure that the air inlets and outlets are unblocked.
IM VT-8242_70x130.indd 6 04.09.2018 17:26:04