5
ENGLISH
•
Do not attempt to repair the unit. Do not disassemble the
unit by yourself, if any malfunction is detected or after it was
dropped, unplug the unit and apply to any authorized service
center from the contact address list given in the warranty
certificate and on the website www.vitek.ru.
•
To avoid damages, transport the unit in the original pack-
age only.
•
For the purpose of environment protection do not discard
the unit with usual household waste after its service life
expiration; hand the unit over to a specialized center for
further recycling.
•
Keep the unit in a dry cool place out of reach of children and
disabled persons.
THIS UNIT IS INTENDED FOR HOUSEHOLD USAGE ONLY
USING THE HOT AIR STYLER
After unit transportation or storage at low temperature
keep it for at least three hours at room temperature before
switching on.
•
Unpack the hot air styler and remove any stickers that can
prevent unit operation.
•
Unwind the power cord completely.
•
Install one of the thermo brushes (1 or 7). To do this insert
the thermo brush (1 or 7) into the hot air styler body (5) and
turn the lock (2) clockwise until bumping.
•
Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
•
Make sure that the operation mode switch (4) is set to the
position «0».
•
Insert the power plug into the mains socket.
•
Set the required settings of the air flow using the switch (4):
«
0
» – the hot air styler is switched off;
«
C
» – «cool» air supply;
«
1
» – low speed and low temperature;
«
2
» – high speed and high temperature.
•
You can change the thermo brush (1 or 7) rotation direction
with the buttons (3). During the operation press and hold
down the button (3), the thermo brush (1 or 7) will rotate in
the required direction.
Note: during the first operation some foreign smell and a
small amount of smoke from the heating element is possible,
it is normal.
•
After the hot air styler operation is finished, switch it off by
setting the switch (4) to the «0» position and unplug it.
•
Wait till the thermo brush cools down.
•
To remove the thermo brush (1 or 7) turn the lock (2) coun-
terclockwise until bumping.
IM VT-8239_70x130.indd 5
31.07.2017 14:29:58
