7
ENGLISH
(3) clockwise in the direction of the inscription
«
INSERT
».
•
Place a suitable bowl on the tray grid (2) and
under the cappuccinator pipe (15).
•
Remove the removable water tank (13) from
the unit and fill with citric acid solution up to
the maximal mark «MAX». After that close the
lid (12) and install the water tank (13) back to
its place.
•
Insert the power plug into the mains socket.
1.
Press the button (9) and wait until the indica-
tor stops flashing and lights constantly.
2.
Turn the steam supply control handle (14) to
the utmost left position and wait until there is
3/4 of the liquid amount left in the water tank
(13), then turn the steam supply control han-
dle (14) to the utmost right position and leave
the coffee maker for 5 minutes.
3.
Repeat steps 1-2 at least 3 times until all the
solution is poured out.
4.
Rinse the water tank (13) and fill it with clear
cold water up to the «MAX» mark.
5.
Turn the steam supply control handle (14) coun-
terclockwise as far as it will go and wait until all
the water is poured out from the water tank (13).
6.
Repeat steps 4-5 twice or thrice.
7.
Switch the coffee maker off by pressing the
button (9) and unplug it.
Notes:
To remove the scale you can use special
descaling agents for coffee makers and coffee
machines, strictly following the instructions on
their usage.
CLEANING
•
If during cleaning of the filter (6) you find out
that the filter (6) openings are blocked with
ground coffee remnants, you can clean the
filter (6) openings with a small brush.
•
Clean the coffee maker body with a soft damp
cloth, and then wipe the unit body dry. Do not
use metal brushes or abrasives.
•
Never immerse the coffee maker body into
water or other liquids.
•
Wash the removable parts of the coffee maker
with warm water and a soft detergent, then
rinse the removable parts and dry.
Drip tray
•
Remove the grid (2) from the tray (1) and pour
out liquid, wash the tray and put it back to its
place, put the grid on the tray.
STORAGE
•
Clean the coffee maker before taking it away
for long storage.
•
Do not store the coffee maker at temperatures
below 0°C.
•
Keep the coffee maker away from children in
a dry cool place.
TROUBLES AND TROUBLESHOOTING
Problem
Cause
Solution
No water/steam.
Not enough water in the tank
or the water tank is installed
improperly.
Warming is not over.
Add water to the water tank. Insert the
power plug into the mains socket and
press the button (9).
No steam
Steam release opening is blocked. Unplug the coffee maker and clean the
steam release opening with a thin wire.
Too little or too
much ground
coffee.
There is too much or too little
ground coffee in the filter (6).
Make coffee at 1 spoon of tampered
coffee per 1 cup of water. Use ground
coffee for espresso coffee makers.
Not enough
espresso after milk
frothing.
After milk frothing the amount of
water in the boiler decreases so
the coffee supply decreases as
well.
After milk frothing perform the actions
described in the section “Heating
water”. This will lead to filling the boiler
with hot water and the coffee supply will
return to normal.
Steam doesn’t froth
milk
You used skimmed milk.
The button (10) indicator wasn’t
lighting constantly when you
started frothing milk.
Use whole milk. Froth milk only after the
button (10) indicator lights up.
IM VT-1524.indd 7
29.06.2016 17:37:39