MANUAL (T RA NSL A TION)
RAY- LG 35X X
Page 10
RAY-LG 35XX
Version: 1.0
Changing the output logic
Output (PNP/NPN) logic is set using the gray wire.
The default logic is LO (light-on) (See Timing
Diagram, p. 11).
The output logic is LO if the gray wire is connected
to GND (0 V). Connecting the gray wire to USP (10
to 30 VDC) changes the output logic to DO (dark-
on) (See Figure 9). If the gray wire is not
connected (floated), the output logic changes to
the OSE signal.
Gray wire
Output logic
Not connected (floated) OSE
Connected to GND (0 V) LO
Connected to USP (10 to 30 VDC) DO
Table 1
: Output (PNP/NPN) logic selection table
LO/DO selector not connected (floated)
LO/DO selector connected to USP
LO/DO selector connected to GND (0 V)
Figure 8: Output logic
