5
CLEANING AND MAINTENANCE
Electronic Cleaning Reminder
Like most appliances, your new water dispenser requires periodic maintenance to operate efficiently.
Your water dispenser must be cleaned every 4 months. For your convenience, your water dispenser is
equipped with a cleaning reminder that will activate following 4 months of use. The yellow light beside
the symbol will illuminate, telling you it is time to clean your dispenser.
Once the unit has been cleaned following the cleaning instructions outlined below, the cleaning
reminder needs to be reset. Reset the reminder by pressing and holding both the HR and MIN buttons
at the same time for 3 seconds. This will reset the cleaning reminder, and it will activate following the
next 4 months of use.
If the unit remains in operation for another month (total of five months operation) and the water
dispenser has not been cleaned and reset, the cleaning reminder indicator (yellow LED) will begin to
flash as a reminder that cleaning is required. Please note that per your warranty, routine maintenance
of the dispenser is required. Failure to maintain the water dispenser will void your warranty.
Childproof safety switch
Dispensing Hot Water
This water dispenser has a power saving Insta-HOT button which activates the water heater only when
pressed, so you get hot water on demand without the cost of constantly heating water!
To dispense hot water, first press the Insta-HOT activation button. The red indicator light
will begin flashing to indicate that the water heater is on and active. In approximately 3
minutes the set temperature point will be reached and the red light will stop flashing and
remain on. The water is now ready to be dispensed. Squeeze the 2 safety switches and
press down on the button until the desired amount of water is dispensed. If water
is not immediately dispensed, the water will begin to cool and the red light will shut off,
requiring you to initiate another cycle.
Childproof Safety Feature
To prevent hot water from accidentally harming a child, the hot water
dispenser button has 2 safety switches on it. Squeeze the safety switches
towards the center of the button and push downward to dispense.
DANGER: The hot water is heated to approximately 194˚ F / 90˚ C.
Temperatures above 125˚ F / 52˚ C can cause severe burns from scalding.
DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND DIRECT SUPERVISION.
