3
Cleaning Kit
Available online at
www.greenwayhp.com
Figure A
OPERATING INSTRUCTIONS
Initial Product Cleaning Procedure
As with most new appliances, there is often a plastic taste upon initial
start-up of the unit. It is recommended to clean the reservoir
prior to first time use.
1
. Make sure the unit is unplugged and the power switch is turned off.
2
. Remove the bottle support collar, saturate a clean cloth with a water
dispenser cleaner or vinegar and wipe the inside of the reservoir.
3
. Pour the water dispenser cleaner or a mixture of 0.3 gal / 1 L of vinegar
with 0.3 gal / 1 L of hot water into the reservoir and wait 20 minutes.
IMPORTANT: To avoid water overflow while cleaning the dispenser,
always remove the bottle support collar before pouring water or the
cleaning solution into the reservoir. (See Figure A).
4
. Press all dispensing buttons until water no longer comes out.
5
. Drain the reservoirs from the drain valve on the back of the unit.
6
. Rinse again with clean water.
7
. Place bottle support collar back on top of dispenser.
Maintaining Your Water Dispenser
Like most appliances, your new water dispenser requires regular cleaning to operate efficiently.
Your water dispenser must be cleaned every 4 months (see procedure on page 5).
Installing the Water Bottle
The water bottle can be purchased from your local retailer.
IMPORTANT: Always wash your hands first! Clean the top (neck) of the bottle with a clean cloth and
do not touch the part of the unit that the water touches. Make sure the unit is unplugged and the power
switch is in the OFF position.
1
. Remove the protective cap from the end of the water bottle unless the bottle has a puncturable
cap or sticker.
2
. Lift and turn the bottle upside down, placing it securely on the bottle support collar.
3
. Press and hold all dispenser buttons until water flows from the dispenser. Drain about 0.3 gal / 1 L of
water before initial use. This does not need to be repeated with replacement bottles.
4
. Plug in the water dispenser.
5
. Set the power switch at the rear of the dispenser to the ON position (see item 13 on page 2).
6
. Ready-to-dispense indicator lights will come on when water reaches optimum temperatures and is
ready for use. In order to get steaming hot water, the Insta-HOT feature needs to be activated.
(See Dispensing Hot Water, pg. 5).
Setting the Analog Clock
To set the clock to the correct time, simply press the HR button
to adjust the hour hand, then press the MIN button to adjust the
minute hand.
!
