Vista SmartDisc 4/10 VLS-04DR-Series, Руководство по установке

Страница: 34 / 74

4 Commissioning
Vista SmartDisc 33
■
SmartDisc supports three operating modes. These are a compromise
between performance and functionality, at the same time leaving the
option to suppress certain functions, under certain circumstances.
SmartDisc factory setting is Duplex mode. Operating mode overview:
■ Simplex = Live image transmission, or recording, or archive
evaluation
■ Duplex = Live image transmission and recording, or archive
evaluation
■ Triplex = Live image transmission and recording and archive
evaluation
■ For applications using several removable hard disks (for increasing storage
capacity or recording time) it is strongly advised to use uniformly
configured hard disks, to use these always in the same SmartDisc , and to
provide them with unique labels. Also refer to chapter (see “Removable
hard disk” on page 27) „Removable hard disk“.
■
SmartDisc is equipped with an integrated clock module with calendar
feature. Maximum deviation at an ambient operating temperature of 40°C
is ±2.5 minutes per month. It is recommended to synchronise the clock
with PC time at regular intervals and to activate automatic adjustment to
summer/winter time.
■ During live transmission SmartDisc displays date and time in the upper
right corner of the picture. To distinguish different images stored at the
same time from each other, a consecutive image number is displayed after
date and time data, separated by a period or a space.
■
Video output operation has no impact on performance or on other
SmartDisc features. Use this output to switch the connected camera with
the V out pushbutton or the V out control output as part of a
sequence, during alarm, or manually.
■
On principle, always assign a Device name and assign unique Camera
names . This facilitates distinction, especially in large projects, not only for
live transmission but also for online and offline evaluation. In addition, you
can define camera groups and pool several cameras into logical groups.
■ Depending on equipment your SmartDisc supports connections to several
SmartControl stations. Simultaneous support is for up to 6 IP
connections, or 5 IP and 1 dialup connection, or 4 IP and 2 dialup
connections. The number of active SmartControl stations connected to
the same SmartDisc at the same time is displayed by the SmartControl
software below the video window. Simultaneous connection to several
SmartControl stations affects SmartDisc performance.
■
You can enter up to four Telephone numbers / IP addresses that will be
processed in the event of an alarm, according to configurable criteria. Field
one has top priority. SmartDisc always dials these numbers consecutively
until one of the receivers is contacted. The number of repeats determines
the maximum number of times the list will be processed. In addition, the
system can be configured to always dial all numbers. The same telephone
numbers will be used for routine calls and for technical alarms. Alarm LED
will remain active until the telephone number list has been processed
according to the set repeats.
■ Select option Alarm call in case of defective Hard Disk if you want to
send a hard disk error message to a SmartControl station. The connection
will be established approximately 45 seconds after the error occurs. If the