Vista QNVR04P, Инструкция по установке и эксплуатации

Страница: 30 / 87

30
QNVR_PoE 4 and 8 channel manual V1.0
QVNR04P/08P installation and user manual
[ Setting the Stream for recording ]
Stream setting includes the following items.
Stream
Select the stream to record on the HDD, it can be set to 1, 2, 3 or 4.
Compression
Select the encoding format of IP camera, it can be set to JPEG, MPEG4 or H.264.
Resolution
Select the recording resolution, it can be set 320x200 to 1920x1080.
Any resolutions can not be supported depending on the IP cameras.
Frame Rate
Select the recording frame rate, it can be set 1 fps to 30 fps.
Quality
Select the amount of compression applied to the recording, there are six levels ranging from
Low to Best.
Click the Apply to save after setting the IP camera parameters.
Note : The stream, compression, resolution, frame rate and quality depend on the
performance of the IP camera.
Note
:
“Record Capacity” shows the remaining frames for recording.
“Display Capacity” shows the remaining channels to display on the monitor.
2.2 Accessing the cameras Web pages
Direct access to the cameras web pages can only be achieved via the IP camera network
ports
– not via the PC Client port, as this is on a physically separate network.
If all Camera ports are occupied, un-plug port 4 on the 4 way or port 8 on the 8 way and
connect the PC or lap top into this port. (Ensure that the PC is set to the same network).
Open a browser (I.E.) and enter the IP address of the camera that need configured.
If the camera that was in port 4 or 8 needs it’s settings adjusted, swap this with another
physical port, make the amendments, Remove the PC and reconnect all cameras.