Vista powerdome pro series, Руководство по установке

Страница: 27 / 83

PowerDome PRO manual V3-6
26
Parapet-Mounting (VPP-ESM)
Preparing the mounting surface
CAUTION:
For all installations, heed the following cautions.
Complete all installation steps before supplying power to the dome.
To ensure proper operation of a PTZ unit, ensure the mount is level.
For safety, the mounting surface, hardware and procedure used for securing the dome must support the weight of the dome,
cables and any structural or environmental vibration according to local regulations. Minimum load for this installation is 4-times
the weight of the dome (see page 13 for weights).
To prepare the mounting surface:
1. The ceiling must be strong enough to bear 4-times the weight of the dome.
2. Mark screw positions.
[Figure 44]
Use the bracket base as a template, mark the screw fixing positions on the wall.
3. Fix the base to the wall. [Figure 45]
Use M8 expansive screws.
4. Install the Pipe Arm to the Base. [Figure 46]
Feed the Power, RS485, video cable through
the bracket’s rings.
Then feed the power, RS485, video cable through the Pipe Arm.
Position the Pipe Arm into the two bracket rings.
5. Fix the Pipe Arm. [Figure 47]
Rotate the pipe arm to the proper place; secure the pipe arm with the two metal hoops.
[Figure 44] [Figure 45] [Figure 46]
[Figure 47]