MENUS AND FUNCTIONS
26
D-307503 PowerMaster 360 User's Guide
6
You can now enroll another proximity tag. You can also select another option in the User Settings menu (see
section A.1), or quit programming (see section A.2).
7
If no proximity tag is enrolled in the system, the display reads [
NO EXISTING DEV.
].
8
To abort the procedure, press the
button.
9
This setting can be performed only after completing steps 1 - 5 of
section B.5A.
10
The
symbol now appears next to the newly selected Partitions.
11
You can now repeat steps 2 - 7 to program or edit another Proximity tag
.
12
You can now add or delete another proximity tag. You can also select another option in the User Settings
menu (see section A.1 and section A.2), or quit programming (see section A.3).
B.7 Add or delete keyfob transmitters
A portable keyfob transmitter may be assigned to each of the user codes 1-48 for better, quicker and safer
arming/disarming and other control functions. Each keyfob should be assigned with a serial No. 1-48 and
enrolled into the system correspondingly.
Partition Option
(For information about the partition option - see Appendix B)
If the Partition option is enabled in the control panel, up to 32 keyfobs can be authorized by the Master User to
arm and disarm any combination, or all 3 partitions, irrespective of the authorization of its corresponding user
code.
Here you can add (enroll) up to 32 Keyfob transmitters and define which of the 3 partitions each of the
keyfob will be authorized to arm and disarm, or delete keyfobs as required.
1. Before anything else, gather up all keyfob units you intend to enroll and make sure they all have
batteries installed and that they are active (the LED blinks upon pressing any of the buttons).
2. Carefully read the section titled "Additional Information" according to the indicated references
1
etc. –
see table at end of this section.
A. To add (enroll) a keyfob
1.
KEYFOBS
Enter the [
USER SETTINGS
] menu, select the [
KEYFOBS
] option and press
.
1
2.
ADD NEW KEYFOB
The display will read [
ADD NEW KEYFOB
].
4
To enroll a new keyfob
press
.
3.
ENROLL NOW or
The display offers you two alternative methods to enroll a keyfob:
ENTR ID:xxx-xxxx
A: ENROLL NOW:
Press and hold the AUX
button on the selected keyfob
until the LED is constantly on.
2
This procedure completes the enrollment.
4a.
DEVICE ENROLLED
If enrollment was successfully completed, a "Success Tune"
☺
sounds and
the display reads [
DEVICE ENROLLED
] for a short duration and then
changes to read the keyfob's details. Continue to step 5.
☺
Go to step 5
4b.
ID No. 300-5786
B:
ENROLLMENT BY DEVICE ID:
Enter the 7-digit number that appears on
the keyfob sticker and then press
to confirm. To complete the
enrollment procedure, see Note 9 in the Additional Information table below.
ID ACCEPTED
If a valid ID was entered, a "Success Tune"
☺
sounds and the display
reads [
ID ACCEPTED
] for a short duration and then changes to read the
keyfob's details. Continue to step 5.
☺
Go to step 5
5.
F01:keyfob
The display shows the allocated keyfob serial No (user No.), which is always
the first free number, and the keyfob's ID number; for example:
[
F01:Keyfob
] alternating with
[
ID No. 300-5786
]
.
ID No. 300-5786
