VisionTrack VT4000, Руководство пользователя

Страница: 12 / 47

12
INSTALLATION
Park your vehicle on a fl at level surface.
Turn o ff the engine before installing the VT4000.
1) Find installation location for VT4000 like in the glove box,
under dash or trunk.
2) Use provided velcro adhesive to secure VT4000 recorder. Velcro can be
attached and detached freely.
NOT E : The adhesive will not stick well with dust or oil, etc.
Please make sure the surface is clean before applying.
3)
INT E RIOR CAM E RA
E XT E RIOR CAM E RA
4) Install the remote controller onto dash within reach of the driver using
provided double side tape.
5) Arrange the power cable neatly alongside of the windshield and door pillar
trim. The VT4000 requires a continuous 12/24volt power source from the
vehicle.
Connect the “Red cable ()” to a fuse. It should be connected to a fuse
that has power all the time from car battery. And the “White cable(AC-C+)”
should be connected to a fuse that has power when you start the engine. The
ground cable should be contacted at the car body or battery negative.
Start on the car after installation.
Install the cameras (sold separately) with double side tape to the
windshield or other flat surfaces as been below. Adjust camera view.
Make sure the lens has an unobstructed view.