VisionTrack VT4000, Руководство пользователя

Страница: 9 / 47

9
FUNCTIONS
G-Sensor Calibration
1. Set G-Sensor Axis using the con fi guration tool.
2. “ selfadj.ini ” should be in the con fi g folder of the SD card.
3. Install the unit and park the v ehicle on a fl at surface .
4. Turn on the unit and wait until it starts recording.
5. Press and hold the “ M1 ” button more than 2 seconds.
6. You will hear “ beep ” when you press the “ M1 ” button and then
you will hear another “ beep ” after 2 seconds. Then release the “ M1 ” button.
7. Then calibration will be done within 2 seconds.
Built-in power backup (Super Capacitor)
When power to the unit is interrupted, VT4000 creates the last
fi le using the internal Super Capacitor.
Time and Date
Set your time zone using the con fi guration tool then VT4000 get’s the time
from the GPS satellite's.
SD Memory Card Format
Please format [initialize] the SD card using the “ Con fi guration Tool VT4000 ”
software.
G-Sensor Calibration is needed after installing the VT4000 .
power and then check the BLUE LED light. Once the LED light
Power o ff the vehicle and take out SD memory card
Turn o ff the
is not on, you can now safely remo v e the SD memory card.
SAFELY REMOVE SD CARD