Vision Multi Axis, Руководство по эксплуатации

Страница: 17 / 41

Chapter 3 - Operations 17
Plates
Clamping plates such as name badges, desk plates and trophy plates are very easy on the MAX Engraver.
Open the clamping device wide enough to accommodate the material you are trying to engrave. To do this, turn the vice
tightening handle counter clockwise to open the vise and clockwise to close the vice. Insert the material into the clamp as
shown in figure 3.9 below.
(Figure 3.9) Clamping flat plates
You must center the material you are engraving on the clamping bars. There is an adjustable material stop that you can
use for quick changing of parts that are the same width. Notice that the ruler is marked from the center out to aid in
centering the material.
For help with setting the spindle and cutters, please see the section on adjusting the spindle.
Pens
Clamping pens requires the use of an optional clamp such as the pen & medallion jig. Mount the pen & medallion jig
onto the clamping device using the 4 included pins & screws to secure it.
Open the clamping device wide enough to accommodate the pen you are trying to engrave. To do this, turn the vice
tightening handle counter clockwise to open the vise and clockwise to close the vice. Insert the material into the clamp as
shown in figure 3.10 below.
(Figure 3.10) Mounting a pen on the MAX engraver