Vision Multi Axis, Руководство по эксплуатации

Страница: 28 / 41

28 Multi Axis Engraver Operating Manual
machine is engraving. Now press start. The job should now engrave. If there are any problems, press the stop button
immediately.
Non Nose Riding Rotary Engraving
In this section, we will set up the spindle to engrave with a rotating cutter and not use the nose cone for depth control.
Figure 3.25 below shows the spindle with a rotary cutter.
(Figure 3.25) The MAX Engraver spindle with rotary cutter
Spindle Pulley
Spindle Housing
Pointer
Micrometer
Retainer Ring
Nose Cone
The first thing that you need to do when rotary engraving with no nose cone is to remove the spindle retainer ring and
nose cone. To do this, unscrew the retainer ring shown in the picture above. Insert the cutter into the spindle and screw
the cutter knob completely in. Note that the cutter will screw in counter-clockwise looking down from the top of the
spindle. There is a small setscrew in the cutter knob. Loosen the setscrew and push the cutter down until there is
approximately 1/4“ of the cutter sticking out below the bottom of the spindle. Tighten the cutter knob set screw.
Note: You will need to lock the spindle so that there is no spring float. To do this, turn the spring adjustment knob to the
left until it reaches the bottom of its travel. This will lock the spindle. See figure 3.26 below.
(Figure 3.26) The spindle spring adjustment knob