Vision Tech Shop TVC Series, Техническое руководство

Страница: 6 / 28

TVC Counting Scale Technical Manual (v1.09b-v1.11)
- 6 -
Installation

Place the scale on a table.

Carefully place the pan to the four holes on the top cover.

Adjust the water mark bubble level.

Connect the adaptor pin to the adaptor jack.
Adaptor jack is located below the right side of the scale.

Adaptor connects into your AC power socket.
Pluggable equipment must be installed near an easily accessible socket
outlet with a protective ground/earth contact.

Turn on the power switch.
On / Off switch is located below the right side of the scale. Press switch
forward to turn on the scale. If you want to turn off, press the switch
backward.

Display will show the scale capacity and will start self-checking.

After self-checking, display will return to normal weighing mode.

Then you can start your operation.
Note: Initial Start Up.
Warm-up time of 15 minutes stabilizes the measured values after switching on.
Level Adjusting
Place the scale on a table.
Check the water mark. If bubble is not centered, adjust the leveling feet until it
becomes centered. Check the level when you change the location.