16
17
VM-H3- User Manual- 072017
VM-H3- User Manual- 072017
and cause a fault.
- Do not use for more than 10 hours. Wait 60 minutes before restarting to avoid
damaging the ultrasound plate.
- Always use cold water. Use only tap water, not mineral or gassy water, etc.
- Never move the appliance whilst it is in use.
- We advise you to wash your hands before and after handling the appliance.
- Keep out of the reach of children and pets. Supervise children to make sure they do
not play with the appliance.
- Take the mains adapter away from passageways and the edges of a table or a counter.
Do not pull the cable.
- If a smell of smoke or burning is detected, immediately disconnect.
Warning :
The quantity and intensity of the mist may vary. It depends on the humidity,
temperature and air currents. If you attempt to run the appliance without water
(pressing the MIST button, you will hear a triple bleep).
Use only 100% natural essential oils. Those containing perfume of chemical origin,
spices or impurities could damage the appliance by fouling the circuits. Pour in 2
to 3 drops at most for 100 ml of water. Clean the appliance in accordance with the
maintenance instructions.
3. OPERATION
1. Put the device on a flat surface. Remove the
cover (do not tilt the device) by protecting the
water tank and carefully turning anticlockwise
then pulling up. Fig1
Use the graduated container to fill the water
tank. Fig3
Watch the water tank level. Do not exceed the
“Max” mark appearing on the outside of the tank.
Do not fill the appliance with water while it is
running. Water and mist might then escape.
Pour the essential oil directly into the tank.
The dosage is approximately 2 to 3 drops
(approximately 0.1 - 0.15 ml) for 100 ml of water.
2. Replace the cover before using the device.
The cover must be on to use the appliance.
Connect the AC adapter to the electrical socket.
Fig2
3. Press the MIST button to operate the appliance. The timer is by default set to 60 min.
Press MIST again to change the duration of operation of your appliance (60 minutes,
180 minutes, 360 minutes, CONTINUOUS / ON and OFF). Fig4
4. Press MIST for a few seconds to switch off the appliance. This operation is required
before disconnecting the appliance.
5. If the volume of water is insufficient, the device shuts down.
If the timer mode is not activated, the LED lighting does not work.
Press the LIGHT button to turn the LED light on or off. 6 alternate colours: red, yellow,
green, blue, violet, white. Fig5
If the appliance is not to be used for an extended time, empty the water tank and
let it dry out.
Appliance falling or accidental leakage during use :
If the appliance is dropped during its use, follow these recommendations to avoid
problems :
- Disconnect the appliance and remove the cover.
- Empty all the water from the tank and the appliance carefully.
- Leave the unit to dry for at least 24 hours.
STEAM
OUTPUT
V. CLEANING AND MAINTENANCE
Depending on the hardness of your water and the use of essential oils, scale may form
on the membrane of the tank. This can disrupt the ultrasound system and vibrations
of the appliance.
To avoid problems, we advise you to look after your Humidoo® by following these steps :
FREQUENCY:
Every 5 or 6 uses or every 2 or 3 days of use :
FIG1
FIG2
FIG4
FIG3
FIG5
