Safety Instructions:
WARNING
- to guard against injury, basic safety precautions should be
observed, including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2.
GROUNDING
-
This product must be grounded. If it should malfunction
or breakdown, grounding provides a path of least resistance for electric
current to reduce the risk of electrical shock. This system is equipped
with a cord having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
DANGER – Improper connection of the equipment-grounding conductor
can result in a risk of electrocution. Check with a qualified electrician or
service personnel if you are in doubt as to whether the outlet is properly
grounded. Do not modify the plug provided with this system – if it will not
fit the outlet, have a proper outlet installed by a qualified electrician. Do
not use any type of adapter with this system.
3.
GROUND FAULT CIRCUIT INTERRUPTER PROTECTION -
To comply
with the National Electrical Code (NFPA 70) and to provide additional
protection from the risk of electric shock, this system should only
be connected to a properly grounded, grounding-type power supply
receptacle that is protected by a Ground Fault Circuit Interrupter (GFCI).
Inspect operation of GFCI as per manufacturers suggested maintenance
schedule.
4.
CAUTION
- Always disconnect power before servicing.
5.
DANGER
- To avoid possible electric shock, special care should be taken
since water is present near electrical equipment. Unless a situation is
encountered that is explicitly addressed by the provided maintenance
and troubleshooting sections, do not attempt repairs yourself, refer to an
authorized service facility.
6. Carefully examine the disinfection system after installation. It should not
be plugged in if there is water on parts not intended to be wet such as,
the ballast or lamp connector.
7. Do not operate the disinfection system if it has a damaged cord or plug, if
it is malfunctioning or if it has been dropped or damaged in any manner.
8. Always unplug the disinfection system before performing any cleaning
or maintenance activities. Never yank the cord to remove from an outlet;
grasp the wall plug and pull to disconnect.
Note:
The UV lamps inside of the disinfection system are rated at an effective life of
approximately 9000 hours. To ensure continuous protection, replace the UV
lamps annually.
2
WARNING
- Always shut-off water flow and release water pressure
before servicing.
