15
www.vintageair.com
901277 REV F 11/18/16, PG 15 OF 24
Figure 13
Figure 14a
Figure 14
Final Steps
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Install duct hoses as shown in Figure 15, Page 16.
Route A/C wires (12 volt/grounds/binary switch/heater valve) through 3/8” grommet as shown in Figure 13,
below.
Install the control panel assembly. Refer to control panel instructions.
Plug the wiring harnesses into the ECU module on the sub case as shown in Figure 15, Page 16. Wire
according to the wiring diagrams on Pages 18 and 19.
Reinstall the glove box.
Reinstall the center console (if equipped). Modify the console as shown in Figures 14 & 14a, below.
Reinstall all previously removed items.
Fill radiator with at least a 50/50 mixture of approved antifreeze and distilled water. It is the owner’s
responsibility to keep the freeze protection at the proper level for the climate in which the vehicle is operated.
Failure to follow antifreeze recommendations will cause heater core to corrode prematurely and possibly burst
in A/C mode and/or freezing weather, voiding your warranty.
Double check all fittings, brackets and belts for tightness.
Vintage Air recommends that all A/C systems be serviced by a licensed automotive A/C technician.
Evacuate the system for a minimum of 45 minutes prior to charging, and perform a leak check prior to
servicing.
Charge the system to the capacities stated on Page 4 of this instruction manual.
See Operation of Controls procedures on Page 20.
3/4”
3 ¾”
MUST
ANG
Passenger Side
Under Dash
Console
Cut &
Remove
Top Side
3/8” Grommet
Firewall
Cover