9
904270 REV D 4/14/15, 1969-72 NOVA w/o AC CONTROL PANEL KIT PG 9 OF 16
TIE WRAP
FORCE BEND
IN WIRES OVER STEP
WIRE
JACKET
STEP IN
CABLE CONVERTER
HOUSING
COLD/HOT CABLE CONVERTER ASSEMBLY
CONTROL HARNESS CONT.
CABLE
CONVERTER
ASM
OEM SCREW
FIGURE 7
WIRE
JACKET
TIE WRAP
3/ 16 PUSH-ON
RING
FIGURE 6b
ONCE WIRES ARE CORRECTLY PLUGGED INTO CABLE CONVERTER ASSEMBLY, SECURE WIRES TO THE CABLE
CONVERTER ASSEMBLY USING TIE WRAPS (SUPPLIED). SEE FIGURE 6b BELOW. THE TIE WRAP MUST BE LOCATED
BETWEEN THE END OF THE WIRE JACKET AND THE STEP IN THE CABLE CONVERTER HOUSING FORCING A
BEND IN EACH WIRE AS THEY PASS OVER THE STEP IN CABLE CONVERTER HOUSING. HEAD OF TIE WRAP MUST
FALL ON EDGE OF HOUSING AS SHOWN TO REMAIN TIGHT. ENSURE THAT THE TIE WRAPS ARE SNUG
ENOUGH THAT THE WIRES CANNOT MOVE. SEE FIGURE 6b.
INSTALL CABLE CONVERTER ASM ON THE COLD/ HOT LEVER. SEE FIGURE 7 BELOW.
INSTALL CABLE CONVERTER LEVER PUSH ROD ONTO OEM CABLE MOUNTING STUD ON LEVER. SEE
FIGURE 7 BELOW.
SECURE THE CABLE CONVERTER ASM TO THE CONTROL PANEL USING THE OEM SCREW IN THE OEM CABLE
CLAMP MOUNTING LOCATION. SEE FIGURE 7 BELOW.
SINCE THE CABLE CONVERTER ASSEMBLY CAN SLIDE BACK AND FORTH IN CLAMP BEFORE SCREW IS
TIGHTENED,POSITION CABLE CONVERTER ASSEMBLY SUCH THAT THE FLAT PART OF THE ROD IS AS CLOSE
TO FLUSH AS POSSIBLE WITH THE END OF HOUSING AT THE LEVER’S INNER MOST POSITION. SEE
FIGURE 5, PAGE 6.
SECURE CABLE CONVERTER LEVER PUSH ROD ONTO OEM CABLE MOUNTING STUD USING 3/16” PUSH-ON
RING AS SHOWN IN FIGURE 7 BELOW.
