- - 10 - -
Chapter 4: Basic Operations
Make Disc-to-Disc Copies
This process will copy your master disc onto one or multiple blank discs simultaneously.
However, due to its simultaneous nature, a good conditioned master disc and a lower recording
speed is recommended for higher success rates and better quality duplications.
For a disc-to-disc copy, the copy source can be any drive connected to the master tower. By
default, the source is preset to the 1
st
drive from the top of the master tower. If the 1st drive is
not functioning properly or cannot read the master disc, you can choose a different drive as the
master reader "source".
During the copying process, it will simultaneously load the master disc image into the hard drive
while copying from the source drive to the writer drives during the first round of the copy process;
then starting from the 2
nd
round, all copies will be made from the hard drive for enhanced
performance and reliability.
Section 1: Selecting the Source Drive.
When you turn on your system, after it has booted up, you should see the following
signifying your system is ready.
Use the up or down arrow button to navigate to the Select Source menu.
Step 1:
Press “ENT”/Enter button to enter the Select Source menu and you shall see a
screen similar to below:
Step 2:
Press the UP or DOWN button to select your desired source drive base on “Drive #”
and press “ENT”/Enter button to make your selection.
DUPLICATOR ( 3)
1.Copy
DUPLICATOR ( 3)
7.Select Source
Drive 0 Port x.x
Pioneer DVDRW DVR-
Drive 0 Port x.x
Pioneer DVDRW DVR-
The “( 3)” indicates there are a total of 3 Towers in this chain.
Typically, drive 0 is an indicator representing the 1st drive on the master tower.
The listing of "Pioneer" above is used solely as an example only. The actual writer drives
installed in this system could vary.
