Vimar RS16.P, Руководство по установке

Страница: 9 / 12

7
RS16.P
EN
9 LED functions
- +
PHC PHO STP
MRX
PWR
- +
PHC PHO STP
MRX
PWR
- +
PHC PHO STP
MRX
PWR
SW1 SW2 SW1 SW2 SW1 SW2
LED Status Description
PWR OFF Mains power supply not present
ON Mains power supply present
MRX 1 blink Saving a new remote control
2 blinks Saving a remote control already in memory
3 blinks Deleting a remote control
4 blinks Radio memory full
5 blinks Attempt to store a remote control with a different code from the one used to set the receiver
10 blinks Complete deletion of the radio memory
51 OFF Step-by-step input (term. 51) not engaged
ON Step-by-step input (term. 51) engaged
52
OFF Pedestrian input (term. 52) not engaged
ON Pedestrian input (term. 52) engaged
61 OFF Stop contact (term. 61) open (engaged)
ON Stop contact (term. 61) closed (not engaged)
62 OFF Photocell engaged when closing (term. 62 open)
ON Photocell not engaged when closing (term. 62 closed)
63 OFF Photocell or safety edge engaged (term. 63 open)
ON Photocell or safety edge not engaged (term. 63 closed)
SW1 OFF Limit switch 1 (corresponding to the right limit switch bracket marked DX) not used
ON Limit switch 1 engaged
SW2 OFF Limit switch 2 (corresponding to the left limit switch bracket marked SX) not used
ON Limit switch 2 engaged
10 Remote control programming
Note: Remote control programming can only be done with the automatic gate system stationary
Step-by-step programming
No. Pressing push button
Signal
MRX LED
Description
1 MRX Off Press and hold down the MRX push button for no more than 7 s
2 MRX + remote control - With the MRX push button still pressed, press the button of the remote control to be saved
3 - 1 blink Button of the saved remote control (new remote control)
2 blinks Button of the saved remote control (remote control already in memory)
Programming the pedestrian
No. Pressing push button
Signal
MRX LED
Description
1 MRX + PRG Off Press and hold down the MRX and PRG push buttons for no more than 7 s
2 MRX + PRG + remote control - With the MRX and PRG push buttons still pressed, press the button of the remote control to be
saved
3 - 1 blink Button of the saved remote control (new remote control)
2 blinks Button of the saved remote control (remote control already in memory)
Deleting a remote control
No. Pressing push button
Signal
MRX LED
Description
1 MRX On steady Press and hold down the MRX push button for at least 7 s until the MRX LED comes on steady
2 MRX + remote control - With the MRX push button still pressed, press the button of the remote control to be deleted
3 - 3 blinks Deletion successful
Complete deletion of the receiver
No. Pressing push button
Signal
MRX LED
Description
1 MRX Flashing light Press and hold down the MRX push button for at least 14 s until the MRX LED starts flashing
2 - 10 blinks Complete deletion of the receiver
Note:
After deleting all the remote controls, the first saved remote control configures the control panel to accept only remote controls with a rolling
code or only remote controls with a fixed code.