Vimar Elvox ECP2, Руководство по подключению и эксплуатации

Страница: 17 / 24

17
Terminal no. Terminal markings Description
21-22 Antenna input:
21 - signal
22 - screen
6. Antenna connection (fig. 5):
7. Dip-switch functions:
No. Position Function
DIP1 OFF Automatic closing off
ON Automatic closing on
DIP2 OFF Pre-flashing off
ON Pre-flashing on (when a command is received, the flashing light flashes for 3 seconds before the
electric motor starts)
DIP3 OFF Automatic operation DIP4 OFF Operation of the START input (terminal 13) and
remote control with 2 step logic:
open-close-open
ON Operation of the START input (terminal 13) and
remote control with 4 step logic:
open-stop-close-stop
DIP3 ON "Dead-man” or “semi-
dead-man” operation
.
DIP4 OFF "Dead-man” operation:
Opening: control held down, releasing the button
will stop the automation
Closing : control held down, releasing the button
will stop the automation
Note: remote control and START input (terminal
13) are disabled
ON "Semi-dead-man” operation:
Opening: pulse control, the START input (termi-
nal 13) works according to the open-stop-open-
stop logic (also remote control)
Closing : control held down, releasing the close
button will stop the automation
Note: activating this mode will disable the auto
closing function
DIP 5 OFF Collective function off
ON Collective function on:
During opening, the START input (terminal 13) and the remote control are ignored
During the pause time the START input (terminal 13) and the remote control reset the pause.
DIP6 OFF Safety device input test on closing SAF1 (terminal 14) off
ON Safety device input test on closing SAF1 (terminal 14) on
DIP7 OFF Safety device input test on opening SAF2 (terminal 15) off
ON Safety device input test on opening SAF2 (terminal 15) on
DIP8 OFF Safety device input on closing SAF1 (terminal 14) and in opening SAF2 (terminal 15) with NC contact
Note: both inputs are with NC contact
ON Safety device input on closing SAF1 (terminal 14) and in opening SAF2 (terminal 15) balanced with
8.2 KΩ resistance
Note: both inputs are balanced
Learning of new Dip-Switch settings without restarting the control unit:
- Press and hold down buttons P1 and P2 for less than 1 sec.
- Release buttons P1 and P2
- The control unit signals the reading of the Dip-switch settings by LED DL7 flashing RED-GREEN for 0.2 sec
EN