22
EN
13F4, 13A4, 13A4.B - 13F7, 13A7, 13A7.B
Terminal block
CN1) Connector for electronic unit.
CN2) Connector for programmer art. 950C or interface art. 692I/U or art. 692I.
B2)
Bus (cable riser).
B1)
Bus (cable riser).
EXT+) External power supply (+ art. 6923).
EXT-) External power supply (- art. 6923).
VLED) LED power supply for additional modules.
X)
Video input (coaxial core) for external camera (13F4, 13A4, 13A4.B).
M)
Video input (coaxial sheath) for external camera (13F4, 13A4, 13A4.B).
PA)
Input for door open sensor (with reference to terminal M).
CA)
Door open command (with reference to terminal M).
M) Ground.
S+)
Lock output 12Vdc (+) (see note below).
S-)
Lock output 12Vdc (-) (see note below).
+12V) 12V (max 120 mA) with current limiter.
-L)
External camera pilot, open collector output (13F4, 13A4, 13A4.B).
SR)
Relay-operated lock pilot, open collector output.
F2)
Relay-operated F2 function pilot, open collector output.
F1)
Relay-operated F1 function pilot, open collector output.
M) Ground.
B2
B1
EXT+
EXT-
VLED
M
PA
CA
M
S+
S-
+12V
-L
SR
F2
F1
M
X
B2
B1
EXT+
EXT-
VLED
M
PA
CA
M
S+
S-
+12V
-L
SR
F2
F1
M
X
CN2
CN1
CS241
1 250105
Figure 3
Note: S+/S- outputs. The entrance panel supplies a current peak of I
T
> 1A for 10 ms,
followed by a holding current of I
M
= 200 mA for the entire duration of the lock command
(see lock time).
Jumper position
SA
connected
configuration as audio electronic
unit (13F4, 13A4, 13A4.B)
disconnected
the video configuration allows
connection of a CCTV type
external camera to the audio
electronic unit
Connection of a CCTV type external camera to an audio electronic unit
To connect an external CCTV camera to an audio electronic unit (13F4, 13A4, 13A4.B), the electronic unit must be configured as if it
were intended for video entryphone use. This type of configuration is accomplished by removing the SA jumper. To perform the operation,
raise the alphanumeric keypad (see figure 4), remove the SA jumper, then reinstate the alphanumeric keypad. Connect the camera as
indicated in diagram SI367).
Figure 4
Figure 5
Figure 6
table 1