Vimar ACTO 404D, Инструкция по установке и эксплуатации

Страница: 16 / 76

14
Preliminary checks
For the automation system to function properly, the structure of the existing gate, or the one to be made, must meet the following requirements:
- The wheels of the gate are mounted in such a position as to provide stability to the gate and are in a good condition and efficient.
- The rail is clear, straight and clean throughout its length with mandatory stops for both opening and closing.
- The top guide is aligned with the rail, the sliding blocks are intact and lubricated and with a clearance of approximately 1 mm. on each side so as to facilitate
the sliding of the gate leaf.
- The spaces between the moving and fixed parts of the gate are of the size required by the national standards or in any case comply with safety standards
by applying an adequate protection system.
- The weight of the gate must not exceed 400 kg
- No mechanical closing locks. It is recommended to take the necessary steps to ensure the reliability and safety of the automation system
General features
Automation system, ESM7, for residential sliding gates. The non-reversible, electromechanical operator is equipped with a low-voltage 24 V DC motor and a
mechanical release which enables the gate to be opened and closed manually. The motor operates a gear unit, lubricated with permanent grease, which is
enclosed in a thick but extremely compact die-cast aluminium housing. The electronic control board is integrated in the body of the operator, with the provision
of a housing for the back-up battery (optional).
Technical specifications
Control unit power supply 230 Vac /120 Vac 50/60 Hz
Input current 0.6 A
Electric motor power supply 24 Vdc
Electric motor power consumption 80 W
Maximum gate leaf length 6 m
Maximum gate leaf weight 400 kg
Opening speed 10 m/min
Maximum torque 9 Nm
Type of use Residential
Frequency of use 50 %
Protection rating IP44
Operating temperature -20°C / +55°C
Pinion for rack M4 Z14
Noise <70 dB
Operator dimensions 295x185x270 mm
Weight 6 kg
Electrical system set-up (standard system)
230 V~
3
5
2
1
4
3
120/230 Vac
2x0.5 mm
2
2x1 mm
2
+ RG58
2x0.5 mm
2
3x1.5 mm
2
3x0.5 mm
2
2x0.5 mm
2
Key
1 - Gear motor
2 - Rack
3 - Photocells
4 - Flashing light with aerial
5 - Selector
EN