Vimar 21553, Инструкция по эксплуатации

Страница: 56 / 74

54
Video door entry system
Setting the flags.
The flags are options that can be turned on/off and affect the behaviour of the video door entry unit; access to the
configuration of the flags is made exclusively with the USB 02024 interface for PC “EVCom”software.
The flags that can be set are given in the following table:
Centralino Enables control via the consumer unit
G3 solo Est. Enables Group 3 only for external calls from panel
G4 solo Int. Enables Group 4 only for intercom calls
Non RIPCH IC Disables call repetition for the intercom
G1 solo Est. Enables Group 1 only for external calls from panel
G2 solo Int. Enables Group 2 only for intercom calls
Grp. Escl. S. If on “User Away,” the secondary ones ring all the same
I.C. Illim. Unlimited duration of intercom conversations
Setting the group calls.
Besides directly setting the secondary identification code (see the chapter "SECONDARY NUMERICAL CODING
OF THE VIDEO DOOR ENTRY UNIT" of this manual) that enables inserting the video door entry unit in a group
of devices (audio/video door entry units) that at the same time receive a call, this association can also be made
via advanced programming with USB 02024 interface for PC “EVCom” software. There are four possible different
groups (G1,G2,G3 and G4); each device can be associated with the single group by indicating (in the specific field
that can be filled in with the aforesaid instruments for advanced programming) the identification code of the master.
Associating landing calls.
Via advanced programming with the USB 02024 interface per PC and “EVCom” software, it is possible (in the
specific field that can be filled in with the above-mentioned instruments for advanced programming) to set the
landing call buttons from which the video door entry unit is able to receive a call.
Each video door entry unit can receive calls up to a maximum of 4 different landing call buttons.