3/44 NT00000792-KUBAIR-F400-ECOWATT-VENTDRIVE-AN-220314
1. GENERAL
1.1 Disclaimers
This product has been manufactured according to rigorous technical rules of safety in conformity with EC
standards. The EC declaration may be downloaded from the Internet site (address given on the last page).
Before installing and using this product, carefully read these instructions, which contain important indications
for your safety and the user’s safety during the installation, commissioning and maintenance of this product.
Once the installation is achieved, keep this manual handy nearby the machine for future consultation.
This product must be installed (installation, connections, commissioning, maintenance) and all other inter-
ventions performed by a professional applying recognized good practice procedures, and respecting the
standards and safety regulations in force. The installation must be made in accordance with the prescrip-
tions indicated in the Electromagnetic Compatibility (EMC) and Low Voltage (LV) Directives.
We advise all people exposed to risks to scrupulously respect the accident prevention standards. The ma-
nufacturer may not be held liable for any human injury and/or material damage resulting from the non-res-
pect of the safety instructions or from a change made on the product.
Smoke extract unit KUBAIR F400 ECOWATT
®
are intended for smoke extraction and ventilation applica-
tions in residential buildings, tertiary buildings, industrial buildings and professional kitchens:
• Outdoor installation
• Environmental temperature range: -40°C / +50°C.
• Max temperature of extracted air in permanent operation: 120°C
• Relative humidity: min 5% - max 90% non-condensing
• Atmosphere not potentially explosive
• Low salinity atmosphere, with no corrosive chemical agents
1.2 Safety instructions
• Wear suitable PPE (Personal Protective Equipment) before any intervention.
• Before installing the roof fan and its accessories, make sure that the support and the location are
sufficiently resistant to withstand the unit’s weight and the accessories, if any.
•
Do not remove mesh grilles to access the impeller before cutting off the electric power supply with
the safety switch.
•
If the work is to be done inside the device, cut off the electric power supply with the main circuit brea
-
ker and make sure that nobody can accidentally switch it back on.
• Make sure that moving parts are stopped.
• Make sure that the impeller is not accessible from connection tappings (connection duct or mesh
protection).
Before starting, check the following points:
• Make sure that the device does not contain any foreign body.
• Make sure that all the components are attached to their original locations.
• Check manually that the impeller does not rub or is not blocked.
• Make sure that the mesh protection are in place.
• Make sure that the ground connection is connected.
1.3 Acceptance – Storage
In case of missing items or delivery of non conforming, partially or totally damaged products, the Buyer
shall make, in accordance with article 133-3 of the French Commercial Code, reservations in writing on the
transporter receipt and confirm them within seventy-two (72) hours by registered letter along with a copy
addressed to the seller. Should the Buyer fail to make reservations when he receives the equipment, he
will not be allowed to make any future claim against us.
The product must be stored protected from the weather, shocks and dirt due to splashings or splatterings
of any kind during transport from the supplier to the end customer, and onto the worksite before installation.
Storage environnement:
Temperature :
-40°C to +70°C /
Relative humidity :
max 95% without condensing.
