Viking VGDO271, Сервисный журнал, Страница: 30 / 52

INSTALLATION INSTRUCTIONS
Converting Oven Burners for Use with LP/Propane
Lower burner orifices and air shutters are located
behind front trim. Remove oven trim to convert oven
burners.
1. Remove oven doors.
•
See “Removing Oven Doors” section.
2. Remove screws (3) from each trim piece.
3. Pull trim away from oven.
•
Each orifice box has an air channel. Air channel
must be in place before reinstalling trim.
•
Reverse procedure to reinstall trim.
A --- Air Channel B --- Orifice Box C --- Trim
4. Turn (tighten) orifice hood clockwise until snug.
•
Do not over tighten orifice hoods. Orifice hoods
can strip.
A – Orifice Hood
5. Replace trim after burner is tested and air shutter is
properly
adjusted.
•
See “Test and Adjust Oven Burner “ section.
Converting Type 1 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
•
Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic
insert firmly into hole in pressure regulator cap.
•
Insert must show “NAT” or be blank.
4. Place pressure regulator cap on pressure regulator
and
tighten.
•
Insert should not disturb spring in body of
regulator.
Converting Type 2 Regulator for Use with Natural
Gas
1. Remove pressure regulator cap with a wrench.
2. Reverse pressure regulator cap.
•
Insert shows “NAT” or is blank.
3. Place pressure regulator cap on pressure regulator
and
tighten.
Converting Oven Burner for Use with Natural Gas
Lower burner orifices and air shutters are located
behind front trim. Remove oven trim to convert oven
burners.
1. Remove oven doors.
•
See “Removing Oven Door” section.
2. Remove screws (3) from each trim piece.
3. Pull trim away from oven.
•
Each orifice box has an air channel. Air channel
must be in place before reinstalling trim.
•
Reverse procedure to reinstall trim.
4. Turn (loosen) orifice hood counterclockwise 2 full
turns.
5. Replace cover plate and storage drawer.
30